Elan DT22-240, Installation Manual

Page: 31 / 73

E L A N H O M E S Y S T E M S
Page 30 © ELAN Home Systems 2009 • All rights reserved.
DT22-240
INSTALLATION MANUAL
Unit ID
The DT22 can provide Two-Way feedback status over VIA!NET to Elan Control Panels without
the use of a SC1 , SS1 or SC4 . The DT22 must be assigned an Unit ID when connected to the
VIA!NET so it can be identified. There can only be two DT22s connected to the VIA!NET.
By default the DT22 is shipped configured to Unit ID 1. For installations with only one DT22,
this setting should not be changed. However, when adding a second DT22 this setting must be
changed to 2 on the second unit
NOTE : The VIA!NET jack on the back of the DT22 must be used.
Highlight Unit ID using the UP arrow or DOWN arrow buttons.
Press the ENTER button.
Unit ID
LCD Settings
Front Panel IR
RS232
Ethernet
DT22 SETUP
MENU
Highlight Edit using the UP arrow or DOWN arrow buttons.
Press the ENTER button.
Press the UP/DOWN arrows to change the Unit ID .
Press the Enter button when done.
Highlight Edit using the UP arrow or DOWN arrow buttons to change the Unit ID .
Highlight Save using the UP arrow or DOWN arrow buttons to save the change.
Highlight Cancel using the UP arrow or DOWN arrow buttons to revert the previous setting.
Press the ENTER button to commit either Edit , Save or Cancel .