DIAMAG
Operating Manual
Page 11
Use of the DIAMAG Device
Using the
«POWER» switch, turn the device
power on. With that, the number of the last program
used shall be displayed in the control board display
box (Fig. 8).
With the help of the
«PROGRAM» button,
set the number of the required program (to be
selected as per the
«Treatment Procedures»
section of the Operating Manual).
Note: In case of a course treatment, when one
and the same exposure program is used, there is no
need for a repeated setting of the program number.
Place the emitters as described in the Operating
Manual, with the working surface marked with
«N» (north pole) turned towards the affected ar-
ea.
For example, Fig. 7 shows placement of the
emitters for treatment of brain diseases.
Note: In order to enhance bio-safety while per-
forming the procedures and to prevent emit-
ters’ contact with the patient’s skin and hair, it
is recommended to use disposable materials (such as a non-woven
cloth or a medical cap).
Press the
«START/STOP» button to
initiate generation of a preset magneto-
action, while the LED display will be
showing the time remaining until the end
of the procedure, with the dot in the lower
right corner blinking (Fig. 9).
After the countdown of the pre-
programmed exposure time is over, a
sound indication of the procedure end will
be generated, and the LED display will
return to the last used program number.
After termination of the exposure procedure, take the emitter off.
If a next magnetotherapy session is not planned, switch the device
off and unplug it from the mains.
Fig. 7
Fig.8
Fig. 9
Blinking dot