090001113
- TECHNICAL MANUAL -
LUPUS2K - VOLANS2K
elmospa.com
3
1. GENERALS
LUPUS2K and VOLANS2K are compact transmitters used for the control of fixtures or for perimetral protections. These
transmitters can be integrated in wireless systems managed by VIDOMO2K and VICOMPACT2K control units (belonging to
the NG-TRX system) or by other expressly compatible control unit models.
Their general features can be summarized as follows:
• LUPUS2K
can transmit the state variations of magnetic contacts and of the roll-up shutter sensor wired to its terminals.
LUPUS2K is identified by the control unit as a multi-channel device; it occupies up to 3 zones for the transmission
of the anomaly/alarm states of the REED magnetic contact (located on housing side), the magnetic contact wired to
the terminal board and the roll-up shutter detector connected to the proper terminal. For the latter, you can properly
configure the number of pulses in a time slot. The detector is fully configurable via software.
• VOLANS2K
can transmit the state variations of magnetic contacts and of the roll-up shutter sensor connected via
wires to its terminals. VOLANS2K is identified by the control unit as a multi-channel device; it occupies up to 4
zones for the transmission of the anomaly/alarm states of the REED magnetic contact (located on housing side), the
magnetic contact wired to the terminal board, the roll-up shutter detector connected to its related terminal and the
built-in inertial piezo sensor. You can properly configure the number of pulses in a time slot and the integration for the
roll-up shutter detector and the piezo sensor. The detector is fully configurable via software; only the sensitivity is
adjustable on the device itself.
The plastic housing features a design in line with current style trends.
Upon request, the “M” brown version is also available.
Note
: the operative range for these devices is evaluated in open field with no obstacles, nevertheless the actual range
might be reduced in case the device is installed in indoor locations with peculiar architectural features. For further details,
consult the features table.
The autonomy is in the order of years of functioning, according to the features of each device.
LUPUS2K and VOLANS2K are IMQ - Security Systems certified.
2. FEATURES
Model
LUPUS2K
VOLANS2K
Protection class
IP3X
IMQ certified
EN50131-2-6: grade 2,
EN50131-5-3
(1)
Environmental class
2
Power supply voltage
3.6 V supplied by 1/2 AA 3.6 V lithium battery mod. ER14250 (supplied as standard eq.)
Low battery threshold
2.5 V with recovery to 2.9 V.
Minimum operating
voltage
2 V for the transmitter;
2.7 V for the LED indicator.
Power consumption @
3.6 V
8 µA idle,
23 mA max.
10 µA idle,
23 mA max.
TX frequency
3 channels (configurable via browser): 868.120 MHz, 868.820 MHz, 869.525 MHz for LPD devices.
Maximum transmitted
power
25 mW
Connection range
nominal/maximum
800 / 1900 m in open field; the range is subject to limitations depending on environmental
conditions. See note.
Note: the ranges refer to 99% reception of the transmitted packets, with the devices
in open field at an height of 1,5 m from the ground, respectively without and with the
orientation of the antenna in the best direction.
The activation of the “tx boost” option, if available, increases the effective range
between 10 and 30% but can significantly affect the battery life.
