LUPUS2K - VOLANS2K
- TECHNICAL MANUAL -
090001113
[email protected]
elmospa.com
2
This product needs batteries for correct functioning. Exhausted batteries have to be delivered to dumping grounds
authorized for battery collection. The materials used for this product are very harmful and polluting if dispersed in the
environment.
EU DECLARATION OF CONFORMITY
DISPOSAL INSTRUCTIONS - INFORMATION FOR THE USER
FOREWORD
FOR THE INSTALLER:
Comply strictly with current standards governing the installation of electrical systems and security systems, and with the manufacturer’s
directions given in the manuals supplied with the products.
Provide the user with full information on using the system installed and on its limitations, pointing out that there are different levels of security
performance that will need to suit the user’s requirements within the constraints of the specific applicable standards. See that the user looks
through the warnings given herein.
FOR THE USER:
Check the system’s operation thoroughly at regular intervals, making sure the equipment can be armed and disarmed properly.
Make sure the system receives proper routine maintenance, employing the services of specialist personnel who meet the requirements
prescribed by current regulations.
Ask your installer to check that the system suits changing operating conditions (e.g. changes in the extent of the areas to be protected, change
in access methods, etc...).
-------------------------------
This device has been designed, built and tested with the utmost care and attention, adopting test and inspection procedures in accordance
with current legislation. Full compliance of the working specifications is only achieved in the event the device is used solely for its intended
purpose, namely:
The device is not intended for any use other than the above and hence its correct functioning in such cases cannot be assured.
Consequently, any use of the manual in your possession for any purpose other than those for which it was compiled - namely for the purpose
of explaining the product’s technical features and operating procedures - is strictly prohibited.
Production processes are closely monitored in order to prevent faults and malfunctions. However, the componentry adopted is subject to an
extremely modest percentage of faults, which is nonetheless the case with any electronic or mechanical product.
Given the intended use of this item (protection of property and people), we invite you to adapt the level of protection offered by the system to
suit the actual situation of risk (allowing for the possibility of impaired system operation due to faults or other problems), while reminding you
that there are specific standards for the design and production of systems intended for this kind of application.
We hereby advise you (the system’s operator) to see that the system receives regular routine maintenance, at least in accordance with
the provisions of current legislation, and also check on as regular a basis as the risk involved requires that the system in question is
operating properly, with particular reference to the control unit, sensors, sounders, dialler(s) and any other device connected. You must
let the installer know how well the system seems to be operating, based on the results of periodic checks, without delay.
Work involved in the design, installation and maintenance of systems incorporating this product should be performed only by personnel
with suitable skills and knowledge required to work safely so as to prevent any accidents. It is vital that systems be installed in accordance
with current legislation. The internal parts of certain equipment are connected to the mains and therefore there is a risk of electrocution
when maintenance work is performed inside without first disconnecting the primary and emergency power supplies. Certain products include
batteries, rechargeable or otherwise, as an emergency backup power supply. If connected incorrectly, they may cause damage to the product
or property, and may endanger the operator (explosion and fire).
In accordance with Directive 2012/19/EU on waste electrical and electronic equipment (WEEE), please be advised that
the EEE was placed on the market after 13 August 2005 and must be disposed of separately from normal household
waste.
IT08020000001624
Hereby, EL.MO. S.p.A. declares that the radio equipment LUPUS2K - VOLANS2K is in compliance with Directive 2014/53/
EU. The full text of the EU declaration of conformity is available at the following Internet address: elmospa.com – registration
is quick and easy.
Radio transmitters for wireless NG-TRX intrusion detection systems
