090001113
- TECHNICAL MANUAL -
LUPUS2K - VOLANS2K
elmospa.com
19
14. BATTERY REPLACEMENT AND DISPOSAL
The LUPUS2K and VOLANS2K detectors use a Lithium 3.6 V 1.2 Ah battery mod. ER14250 or LS1425 (1/2AA). Replace
this battery only with a new one of the same model. Observe the following insertion instructions:
1. Remove the low battery.
2. Press and release 3-4 times the Tamper button to discharge any charged capacitors.
3. Check the distance of the battery clip tabs. In idle conditions, they have to take an inclination similar to that shown in
the figure. The distance between the two tabs should be about 25 mm; if more, you will have to push them inward to
obtain the indicated distance.
The correct position of the tabs allows an excellent electrical contact and avoids possible and erroneous signalling of
low battery.
4. Insert the new battery. Check the polarity.
5. Reset any low battery memories in control unit or in the compatible receiving device.
Dispose of the old battery in full compliance with the current regulations, using the appropriate containers.
The materials used are highly polluting and harmful if released to the environment.
25 mm
