/ 26 /
Fitting Ring
Fitting Ring
STEP 3
If you have assembled the components according to this
installation manual, you should have all of the compression
fittings already installed.
In order to install the tubing onto the compression fittings, you will
have to remove the fitting rings by rotating them in the counter-
clockwise direction.
STEP 4
Slide the fitting ring along the tube with the threaded side facing the
fitting barb.
Install the tube on the fitting barb. If needed, heat the tube with
warm water. You can do that by forcing it to slide over the edge as
far as it goes.
STEP 5
Slide the fitting ring towards the barb and tighten it in the clockwise
direction as far as it goes.
Repeat the procedure on all the fittings in order to connect the water
cooling loop.
Tubing
STEP 3
STEP 5
STEP 4