/ 25 /
CONNECTING THE TUBING
If you are adding an additional unit to the water cooling
loop, please proceed to Page 33, chapter POSSIBILITIES
OF EXPANDING THE SYSTEM.
STEP 1
In order to successfully route the tubing, it is recommended that you
check the water cooling scheme on the picture.
It is best that the water block receives the coldest fluid as possible,
therefore you should connect the radiator’s outlet port with the water
block’s inlet port. This is the best practice but it is not mandatory.
STEP 2
Visualize the tube’s routes and then measure the distance by trying
to fit it into the chassis. Mark the required length with a marker.
Before cutting, it is recommended that you leave the additional 2 or
3 centimeters to spare. You can shorten it afterward. You may use
the enclosed »Soft tube cutter« to cut the tubes.
Please make sure that the tube is not bent or twisted. This
way, the coolant will be able to flow without restriction.
CPU Water
Block
Radiator
with Fans
COLD AIR
HOT AIR
Reservoir-Water Pump Combo
STEP 1
PC Chassis
Tubing
Radiator with
Fans
STEP 2
