EKOM DK50-10 S, User Manual

Page: 41 / 276

DK50-10
01/2022 - 41 - NP-DK50-10-16_01-2022-MD
Prolonged operation
of the compressor Leak from pneumatic distribution
system
Worn piston ring
Inlet filter is plugged
Defective solenoid valve Check compressed air distribution
system
– seal loose joint
Replace worn piston ring
Replace old filter with a new filter
Repair or change the valve or coil
Compressor is
noisy (knocking,
metal noises) Damaged piston bearing, piston rod,
motor bearing
Loose or cracked spring Replace damaged bearing
Replace damaged spring
Dryer doesn't dry
(condensed water in
the air) * Cooling fan not working Replace the fan
Check the power source
Damaged dryer Replace the dryer
Non-functioning automatic
condensate drain Clean / replace
)* After a dryer malfunction, the interior surfaces of the air tank must be thoroughly cleaned and all
condensed liquid removed.
Check the dew point of the air leaving the air tank (see Chapter 7 - Technical data) to protect
the device from damage!
REPAIR SERVICE
Guaranteed and post-guarantee repairs must be done by the manufacturer, its authorized
representative, or service personnel approved by the supplier.
The manufacturer reserves the right to make changes to the device without notice. Any
changes made will not affect the functional properties of the device.
STORAGE
If the compressor will not be used for a prolonged time period, drain all condensate from the air tank.
Then turn on the compressor for 10 minutes, keeping the drain valve open (1) (Fig. 10). Switch off
the compressor using the switch (2) at the pressure switch (1) (Fig. 9), close the drain valve and
disconnect the device from the mains.
DISPOSAL OF THE DEVICE

Disconnect the device from the mains.

Release air pressure in the pressure tank by opening the drain valve (1) (Fig. 10).

Dispose of the device following all applicable environmental regulations.

Entrust a specialised company to sort and dispose of waste.

Worn out components have no negative environmental impact.