EKOM AD2250, User Manual

Page: 8 / 92

GENERAL INFORMATION
NP_AD500-2250-1_01_2020 -8- 01/2020
Any other use of the product beyond the intended use is considered as incorrect use. The
manufacturer is not responsible for any damages or injuries as a result of incorrect use or
disobedience to instructions stated in this User manual. All risks shall be solely borne by the user /
operator.
4. GENERAL SAFETY INSTRUCTIONS
The product is designed and manufactured so that any risks connected with its use are minimized
and the product is safe for the user and surrounding when used according to the intended use and
the instructions stated below are followed.
4.1. Required qualification if the personnel

Each user must be trained by the manufacturer or an organization authorized by the
manufacturer or instructed on the device operation by other trained user.

Installation, new settings, changes, extensions and repairs of the product may be performed by
the manufacturer or an organization authorized by the manufacturer (hereinafter qualified
technician).
- Otherwise the manufacturer is not responsible for safety, reliability and correct function of
the product.
4.2. General instructions

When operating the dryer, all acts and local regulations valid in the place of use must be
observed. The operator and user are responsible for following the applicable regulations.

Before every use, the user must check, if the device is functioning correctly and safely. Before
building the dryer in other devices, the supplier must assess, if the supplied air and construction
of the device comply with the requirements of the specified intended use. Taking this into
account, follow the product technical data. Assessment of conformity shall be performed by the
manufacturer
– supplier of the final product.
4.3. Protection from dangerous voltage and pressure

The device can be connected only to a properly mounted socket with protective earthing.

Before connecting the product, check if mains voltage and mains frequency stated on the product
are in compliance with the values of the mains.

Before putting the product into operation, check eventual damages to connected pneumatic
hoses and electrical cables. Replace damaged pneumatic hoses and electrical cables
immediately.

Immediately disconnect the product from the mains (pull out the mains plug) in hazardous
situations or technical malfunctions.

Relief valve settings must not be changed and it must not be used to depressurize the device.
4.4. Original spare parts and accessories

Safety of operating staff and failure-free operation of the product are guaranteed only when
original spare parts are used. Only accessories and spare parts stated in the technical
documentation or explicitly approved by the manufacturer may be used.

The warranty does not apply to damages arising from use of accessories and spare parts other
than prescribed or recommended by the manufacturer and the manufacturer is not responsible
for them.