EKO INSTRUMENTS CO., LTD. VIP Checker HC-121 Instruction Manual V2
Pg. 29
Entering from Keyboard
This method is effective only when the mode is in
the Barcode Reader mode.
Click [F5] from the Keyboard. The dialog box for
entering serial numbers on the display window.
Enter the serial number from the keyboard and
click OK. (Available up to 13 digits.)
6)
Place the Sensor Unit of the measuring channel on top of the sample; when the Start button on the
Display Unit of the same channel is pressed, the light turns off and starts the measurement. The
indication of the Probe
Measureable
surement time
count starts and the display changes to below.
Place the Sensor Unit on the center of the VIP which is flat.
After 30 seconds, buzzer will sound and Start button starts blinking then the measurement is completed.
The Display Unit indicates
d the evaluation result will
be displayed.
7)
Return the Sensor Unit back to the Heatsink.
Push Start button.
When the Cooling time is over, the Start button is light again.
Repeat the same process from 4) to 6) by sorting the next VIP.
Approximately within 1 minutes, 5 VIP can be inspected.
Please be careful that the indications of serial number, thermal conductivity, and evaluation result
are cleared once the Start button is pressed. The saved data will not be erased.
Figure 6-40. Enter Serial Number Dialog
Figure 6-42. Measurement Completed Display
Figure 6-41. Measuring Display
