EKO INSTRUMENTS CO., LTD. VIP Checker HC-121 Instruction Manual V2
Pg. 27
4. Measurement Procedure
1)
When the power switch on Controller is turned ON, the lamp on the Display Unit will light and buzzer will
sound in order from the Channel 1. Then all the lamps turn off.
When there is any lamp that does not light, please check the condition of connector on that channel.
If the lamp does not light even after checking the connection, it is considered to be broken.
2)
Start the Measurement Software TCDac.
ure
6-33. Initial Window. At this time, the Start button on the Display Unit is in Stand-by status.
3)
Press the Start button which is blinking on the Display Unit. The blinking will stop after the button is
pressed. The Probe Status on the Measurement Software display
4)
Measureable
reading disable
reading enable
setting enable
Figure 6-36. Start Measurement Display
Figure 6-37. Measureable Display
