EKO INSTRUMENTS CO., LTD. VIP Checker HC-121 Instruction Manual V2
Pg. 17
3. Calibration Software Operation
1)
Starting Calibration Software
According to the [6-1. Installation and Uninstallation], [3. COM Port Setting], set the COM port on PC.
The COM port setting is saved once it is setup.
After the COM port is setup, the Calibration Software starts up and below window appears.
2)
Registering Barcode Number for Calibration VIP
Name the VIPs (reference VIPs) with appropriate name or number for calibration as Sample 1, 2, and 3,
and register the barcode numbers (serial numbers). Click the Set
c
the window.
Registration dialog is displayed for barcode numbers. Enter the serial numbers in an order from the
lower thermal conductivity. When finish entering the numbers, click OK.
When there is no barcode on the VIP, use 3 different numbers or names to identify each VIP.
3)
Entering Thermal Conductivities
Enter the thermal conductivities for each Sample 1, 2, and 3 at the very bottom section of each sample
items. Enter the values in [mW/mK].
Figure 6-14. Evaluation Standard
Reference Value
Near-Value
Thermal Conductivity [W/mK]
Output
4.00
6.00
OK
NG
nNG
Approximation Curve
Figure 6-15. TCCal_Vxxx Start Up Window & Registering Barcode Numbers
