12
EIGHT
PINS
Tighten the postpin
with a torque wrench with
8 Nm.
Rotate the outer sleeve by
rotation so that the moun-
ting hole of the outer sleeve
coincides with the mounting
hole on the frame.
Screw the M5 mounting
screw of the outer sleeve
into the outer sleeve with a
3mm Allen key.
Attention! The screw must be easy to screw into the outer sleeve. If this is not the case, perhaps the hole in the
frame does not coincide with the mounting hole of the outer sleeve. The frame can be squeezed or damaged
Assembly of the remote lever
The cable system of the Eightpins seatpost consists of a common cable housing with a Steel core and a short, more fl exible cable housing with
an Aluminum core directly at the remote lever. The cable system right at the remote lever consists of a 10 cm Aluminum cable housing, a specifi c
cable tension adjusetr and a specifi c end cap for the remote lever featuring a reduced outer diameter. The specifi c end cap is installed at the one
end of the cable housing, the cable tension adjuster at the other end. The cable tension adjuster is installed so that the side with the 4 mm label is
connected with the Aluminum cable housing. The second end is attached to the steel cable housing that reaches out of the frame..
Note: Initially, put the cable tension adjuster into the minimum cable length position.
Summary of Contents for NGS2
Page 8: ...8 EIGHTPINS...
