EHP IoT Box, Technical Manual, Page: 13 / 31

The Net-Scale must be configured for operation with a scale. This is done via entries in an "NSC.INI"
file on the SD card. Operation without an INI file is not possible!
FREQ=x Frequency channel for communication with the scale (1-28)
DIMZ=kg Dimension sign (two digits)
NKOM=0 Number of decimal places;
When this line is deleted, the decimal value of the scale is automatically
taken over
IPAD=xxx.xxx.xxx.xxx IP address FIX (without DHCP)
As default IP address 192.168.0.2 is set. If another IP-address should be
used please contact your EHP contact person
MASK=255.255.255.xxx Subnet Mask (without DHCP)
GATE=xxx.xxx.xxx.xxx Gateway
PORT Port for the assignment of the service. Freely selectable from 1 to
65535. (Default port is 187, when selecting the port, make sure that it
does not collide with any other service).
WDHL=1...5 Number of communication attempts between Net-Scale and scale
ACT= 1.....16
(from firmware 2.12)
Permanently activate communication to scales
By entering the scale number in the INI file, a permanent connection is
established, independent of the configuration of the network interface.
A separate entry must be created for each scale.
This facilitates the integration of the Netscale in order to be able to use
commands such as "Register weight
– 10 without any programming
effort or to establish communication with an EHP large display if no
permanent IT connection of the network interface is provided.
Note: When using a large display, the Netscale is limited to use with a
scale.
Table 2 -INI file entries
The SD card is mounted as an ftp drive as soon as the net-scale is supplied with voltage. If the SD
card is removed during operation, it must be mounted again. To do this, disconnect the Net-Scale
from the power supply and reconnect it after a few seconds.
The INI file must be named in capital letters (file name: NSC.INI)!