26
|
27
7.4.2 On / Off function
The first time you use your EGO FLASH, you must start the EGO FLASH by turning the ignition key. You will see the starting logo
and the main display screen. If no connection to a mobile phone exists or no user is found, the functionality of the main menu is
restricted.
In order to connect to the EGO FLASH, you must select the “User management” menu item with
. “New user” is then se-
lected. The EGO FLASH will then search for mobile phones within its range of reception. If it fails to find your mobile phone, you
may repeat the search, or read the section on “Troubleshooting”. When the name of your mobile phone is shown, select it with
the
key. After a connection is established with the EGO FLASH, the main menu is fully functional. Functionalities that are not
supported by the mobile phone are not selectable. If the ignition is switched off, the EGO FLASH shuts itself off. If the ignition is
switched off during a phone call, the call continues without interruption. The EGO FLASH will shut itself off only after the phone
call is ended.
7.4.3 Enter Bluetooth
®
PIN
After a few seconds you will be prompted to enter your Bluetooth
®
PIN. Enter the PIN shown on the EGO FLASH display onto your
mobile phone.
7.4.4 Hands-free mode
In some cases, coupling with your mobile phone in the hands-free mode does not work when using the method described above. If
you are sure that your mobile phone supports the Bluetooth
®
hands-free profile, proceed as follows: In the list of detected devices,
select “couple from phone”. Now you need to search for Bluetooth
®
devices using your mobile phone. The procedure for this can
be found in the operating instructions for your mobile phone. The mobile phone will then start searching for devices. Select the
EGO FLASH from the list of devices found by your mobile phone. During the coupling process, your mobile phone will prompt you
to enter a PIN or password. At this point, please enter the series of numbers shown on the display of the EGO FLASH. After a short
time, the mobile phone should inform you that coupling was successful. You may also cancel the coupling at any time by pressing
the
key. If coupling fails, please read the section on “Troubleshooting”..
7.4.5 Automatic coupling
If the phone is already connected with the EGO FLASH, the EGO FLASH will try to couple to this phone. If the search is successful,
a connection is automatically established. A search is always performed for the most recently connected mobile phone.
If the search process was unsuccessful, it‘s possible that Bluetooth
®
or the mobile phone is not turned on, or that you were not the
last user. If you would like to select another user, activate user management and log this user in.
7.4.6 Call
If there is an existing Bluetooth
®
connection between the EGO FLASH and a mobile phone, you can use the hands-free function of
the EGO FLASH. If there is no connection, you cannot use the hands-free function. You must first establish a Bluetooth
®
connec-
tion. You may dial a number with voice-activated dialing, through the menu or directly on the mobile phone.