EFI Fiery ES IC-418, Configuration And Setup, Page: 133 / 243

Gangup layout options
Gangup
layout options are used for speed printing imposition modes.
Note:
The Gang-up feature is not valid if your job is sent to the Direct connection.
Gangup
Select
Gangup
to specify options for speed printing imposition modes.
Gang-up type
Gangup booklet has two types used for speed printing imposition:
Step & repeat
and
Cut & stack
.
Select
Step & repeat
to speed print a job by printing two document pages on each sheet. When the printed
sheets are cut in half, the result is two complete sets of the same document.
Select
Cut & stack
to speed print a job by printing two document pages side by side. When the printed sheets are
cut in half and stacked together, the result is one complete set of the document (in faster printing time).
For more information, see
Gang-up printing on page 101.
Page Alignment: Duplex
The
Page Alignment: Duplex
print option allows you to select the duplex (double-sided) setting to specify the
orientation of printed images for gang-up printing.
Select
Off
for single-sided printing.
Specify
Right & left binding
for duplex (double-sided) printing to specify the orientation of printed images.
For more information, see Print Duplex (double-sided) pages on page 103.
Page Alignment: Increase gutter by
Increase gutter by
controls the amount of space between adjacent pages on a sheet to adjust for trimming or
other finishing options.
You can specify the gutter value from -1.969 to 1.969 inch in 0.001 inch increments (-50.0 to 50.0 mm in 0.1 mm
increments).
Specify a positive value to increase the amount of blank space between adjacent pages.
Specify a negative value to decrease the amount of blank space between adjacent pages.
For more information, see
Booklet Maker Help .
Printing
Print Options
73