S
ETTING
UP
FROM
THE
C
OPIER
C
ONTROL
P
ANEL
34
IPv4 Address
Choose this option if a TCP/IP network is connected to the E-42B over Ethernet cabling.
Use DHCP
Choose whether to allow the E-42B to obtain its Ethernet IP address and subnet mask
automatically by searching the network, using DHCP. Depending on the network, the IP
address can change. To confirm the IP address of the copier/printer and the E-42B, save your
changes to Setup and print the Configuration page (
).
Make sure that the network is configured properly for the protocol that you choose.
Manual Configuration
If you do not use DHCP, choose whether to manually assign the E-42B a static IP address,
subnet mask, and gateway. Enter the information in the appropriate fields.
IPv6 Setup
Enable IPv6
Choose whether to allow the E-42B to retrieve an IPv6 address from the network.
N
OTE
:
To enable IPv6, you must first enable IPv4.
DNS Setup
You can configure the E-42B so that it can access an appropriate DNS server. With the DNS
server, when connecting the utilities or WebTools from remote computers to the E-42B, users
must remember only its Server Name, which is easier to remember than an IP address.
Get DNS Address Automatically
Choose whether to allow the E-42B to obtain its DNS address automatically. If you do not
enable this option, use the following options.
Primary DNS Server
Specify the IP address of the primary DNS server.
Secondary DNS Server
Specify the IP address of the secondary DNS server.
Domain Name
Enter the DNS domain name.
N
OTE
:
When you change Domain Name, the Server Name (
) and Windows Printing
Server Name (
) change also.
