PD00E0XKNXFI00020100_HANDBOOK_EN.DOCX
PD00E0xKNX KNX PRESENCE DETECTORS RANGE Handbook
Eelectron SpA, Via Monteverdi 6,
I-20025 Legnano (MI), Italia
Tel: +39 0331.500802 Fax:+39 0331.564826
E-mail: [email protected] Web:
C.F. e P.IVA 11666760159
Tribunale di Milano 359157-8760-07
CCIAA Milano 148549
8/46
Bit to Byte conversion
Byte to Bit conversion
Threshold functions for 1,2,4 Bytes objects
Logics to manage Fan coil speeds
Logics to manage dew point calculation
Logics to manage telegrams surveillance
3.
Installation instructions
Warning
The device may be used for permanent indoor
installations in dry locations within wall box
mounts..
WARNING
Device must be installed keeping a minimum
distance of 4 mm between electrical power line
(mains) and input cables or red / black bus cable.
The device must not be connected to 230V
cables
The prevailing safety rules must be heeded.
The device must be mounted and commissioned
by an authorized installer.
The applicable safety and accident prevention
regulations must be observed.
The device must not be opened. Any faulty
devices should be returned to manufacturer.
For planning and construction of electric
installations, the relevant guidelines, regulations
and standards of the respective country are to be
considered.
KNX bus allows you to remotely send commands
to the system actuators. Always make sure that
the execution of remote commands do not lead
to hazardous situations, and that the user always
has a warning about which commands can be
activated remotely.
Hints
Illuminance measurement
Ambient illuminance measurement is performed
indirectly and calibration is therefore necessary.
The sensor is installed on the ceiling and the
detected illuminance can differ significantly from
that of the work surface; using the SW ETS it is
possible to set correction parameters for the device
on the basis of an on-site measurement using a lux-
meter
Do not allow sunlight or artificial light to directly
irradiate the sensor.
Presence and movement detection
The sensor allows you to set different sensitivity
levels; read with care the following notes for correct
installation of the device and setting of the
sensitivity parameters.
The sensor detects the difference between the
ambient temperature and the temperature of
moving objects and people; the lower this
temperature difference, the less sensitive the
sensor will be.
For a correct coverage of the sensor surveillance
area, avoid that walls (including glass) or
furniture are an obstacle; if this is not possible,
increase the number of sensors in the area for
complete coverage.
Always mount the sensor on a stable site, not
subject to vibrations or oscillations that can
simulate movement.
Lighting fixtures placed near the sensor or in the
monitored area can cause false detections, avoid
this type of interference as much as possible.
Avoid to place in the coverage area there are
appliances that produce heat such as fan coils,
printers, lamps, etc. or objects that move
because of the wind or drafts.
Please see datasheet at: www.eelectron.com
4.
General parameters
PARAMETRO KNX
IMPOSTAZIONI
Delay to send telegrams
on power up [s]
5 ÷ 15
Through this parameter is possible to set the delay of
