RCX C-Link User’s Guide
EDT, Inc. November 2006
ii
The information in this document is subject to change without notice and does not represent a commitment on the part
of Engineering Design Team, Inc. The software described in this document is furnished under a license agreement or
nondisclosure agreement. The software may be used or copied only in accordance with the terms of the agreement.
Engineering Design Team, Inc. (“EDT”), makes no warranties, express or implied, including without limitation the implied
warranties of merchantibility and fitness for a particular purpose, regarding the software described in this document (“the
software”). EDT does not warrant, guarantee, or make any representations regarding the use or the results of the use
of the software in terms of its correctness, accuracy, reliability, currentness, or otherwise. The entire risk as to the
results and performance of the software is assumed by you. The exclusion of implied warranties is not permitted by
some jurisdictions. The above exclusion may not apply to you.
In no event will EDT, its directors, officers, employees, or agents be liable to you for any consequential, incidental, or
indirect damages (including damages for loss of business profits, business interruption, loss of business information,
and the like) arising out of the use or inability to use the software even if EDT has been advised of the possibility of such
damages. Because some jurisdictions do not allow the exclusion or limitation of liability for consequential or incidental
damages, the above limitations may not apply to you. EDT’s liability to you for actual damages for any cause
whatsoever, and regardless of the form of the action (whether in contract, tort [including negligence], product liability or
otherwise), will be limited to $50 (fifty U.S. dollars).
No part of this manual may be reproduced or transmitted in any form or by any means, electronic or mechanical, without
the express written agreement of Engineering Design Team, Inc.
©
Copyright Engineering Design Team, Inc. 1997–2006. All rights reserved.
EDT and Engineering Design Team are trademarks of Engineering Design Team, Inc.
3M is a trademark of 3M Corp.
This device complies with part 15 of the FCC Rules. Operation is subject to two conditions: (1) This device may not
cause harmful interference, and (2) this device must accept any interference received, including interference that may
cause undesired operation.
CAUTION:
Changes or modifications not expressly approved by Engineering Design Team, Inc. could void your
warranty to operate this equipment.
NOTE:
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to
part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when
the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful
interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful
interference in which case the user will be required to correct the interference at his or her own expense.
