Version of 26 April 2016
19
Menu functions and settings:
DVB-C Setup:
Use the OK button to switch to the DVB-C settings menu (see below).
Region:
Select your region here.
Tuner Power:
Here you can set extra voltage for reception via DVB-C.
Functions and settings in the search and setup menus for DVB-C:
Scan mode:
Define the channel scan by inserting a specific frequency or an entire
frequency band.
This item is available only if you have not selected the ‘Frequency
input’ in the ‘Scan mode’ menu. You can then choose between UHF
and VHF.
Program position number:
This item is available only if you have not selected the ‘Frequency
input’ in the ‘Scan mode’ menu.
Here you can set the program position number and its frequency.
Frequency:
This item is available only if you have not selected the ‘Frequency
input’ in the ‘Scan mode’ menu. Then enter the desired frequency.
Frequency selection:
This item is available only if you have not selected the ‘Frequency
input’ in the ‘Scan mode’ menu. Then enter the frequency here.
LCN:
Here you can choose whether the channel names are to be included
in the scan.
Use the red button to switch to the scan menu. In the ‘Scan Mode’ item you can select between ‘All’ and
‘Free’. If you select ‘Manual Scan’ at the next item and press the OK button, the scan process begins
according to the settings made. At this point, if you select ‘Blind Scan’, then some of your settings may not be
taken into account during the scan. ‘Blind Scan’ automatically scans for all available satellites.
Exit the ‘DVB-C Setup’ menu by pressing the
EXIT button.
Satellite Guide
This menu item will be helpful
when adjusting the satellite
installation.
Menu functions and settings:
Local longitude:
Define
the value for the longitude of
the place where the satellite
reception facility is.
Local latitude:
Define the
value for the latitude of the place
where the satellite reception
facility is.
Calculation:
Navigate the cursor using the arrow buttons on this specific item and press the OK
button. The orientation and altitude values are calculated automatically.
Exit the ‘Satellite Guide’ menu pressing the
EXIT button.