Edirol VC-50HD SDI 1394, Owner'S Manual

Page: 27 / 37

27
Other mode settings
By setting the mode select switches located on the VC-50HD’s side panel, you can select the audio
channels that will be output, and allow remote control from a computer.
Specifying the audio input/output channels
For the SDI embedded audio, only the two specific channels you select will be input and output. Make
settings as follows to specify the channels that will be input and output.
* The VC-50HD does not support HDV/DV four-channel audio. If four-channel audio is input, only the two
channels 1/2 will be selected.
Selecting which two SDI audio channels go into IEEE 1394
Make the following settings to determine which two channels will go to IEEE 1394.
* If SDI is the source, turn switch 1 to OFF.
fig.audio-chart-SDI.eps
Selecting where your two IEEE 1394 audio channels will be encoded to SDI
Make the following settings to determine which two channels will go to SDI.
* If IEEE 1394 is the source, turn switch 1 to ON.
fig.audio-chart-1394.eps
1/2 ch 3/4 ch
5/6 ch 7/8 ch
OFF
ON
ON
OFF
ON
OFF OFF OFF
OFF OFF OFF OFF
1/2 ch 3/4 ch
5/6 ch 7/8 ch
OFF
OFF
ON
ON
OFF
ON
ON
OFF
OFF
OFF OFF
ON