67
Using the audio effects
Connecting the speakers
fig.4-16a
At the factory settings, the
OUTPUT 2
jacks are set to
output the signals from the internal sound generator.
If you want to use surround reverb as the audio effect,
you must connect external speakers to the
OUTPUT 2
jacks, and make settings so that these jacks output the
signal for the rear speakers.For best results, try to
listen from the “sweet spot” shown in the diagram at
right.
It is best to set the
VOLUME
knob to approximately
the two o’clock position. However, since the
VOLUME
knob cannot be used to adjust the output of the rear
speakers, you should turn the
VOLUME
knob slightly
down if it is difficult to hear the output of the rear
speakers.
Using surround output
fig.4-17
*
When surround reverb is used, it may be easier for the output to become distorted. Watch the level meters shown in
the display, and make adjustments so that the levels of the audio and the internal sound generator are appropriate.
1.
Press
[SYSTEM]
.
2.
Press
[PAGE
]
or
[PAGE
]
until
Select Output 2
is displayed.
fig.dummy(fig.4-18)
3.
Turn the
[V1]
knob to select the output for the
OUTPUT 2
jack. For this example, select
REAR
.
Select Output 2
AUTO:
Normally, the sound of the internal sound
generator will be output. If Surround Reverb
is being used as the audio effect algorithm,
then the sound for the rear speakers will be
output.
INST:
The sound of internal sound generator will always be output.
REAR:
The audio effect sound will always be output. If an algorithm other than Surround Reverb is
used, nothing will be output.
60
°
60
°
60
°
60
°
1, 4
3
2
sd90_manual_e.book 67 ページ ２００４年１０月４日 月曜日 午後３時２８分
