Edgetech 3200-XS, User Manual

Page: 42 / 74

3-10
SECTION 3: Setup and Test
3200-XS Sub-Bottom Profiling System User’s Manual Doc. No. 990-0000026-1000, Rev. 2.3
3.7.2 Connecting the Deck Unit
To connect the Deck Unit:
1.
Verify that the Deck Unit is not connected to AC power.
2.
Refer to “Selecting the Power Amplifier Input Power Voltage” on page 3-2 and select or
verify the correct input power voltage.
3.
Verify that the tow cable is properly connected and attached to the tow vehicle, and
then connect the tow cable to the SEA CABLE connector.
4.
Connect the LCD monitor to the MONITOR connector.
5.
Connect the trackball to the TRACKBALL connector.
6.
Connect the keyboard to the KEYBOARD connector.
7.
If a printer is to be used, connect the printer to the PARALLEL connector. For
information on the printers that can be connected to the 3200-XS Sub-Bottom Profiling
System, refer to “APPENDIX A: Printer Connections.”
8.
If a navigation system is to be used, connect the navigation system output to the
COM 1-NAV connector.
9.
If an external source is to be used to trigger the 3200-XS Sub-Bottom Profiling
System, connect the trigger output of this source to the TRIGGER IN connector.
10.
If an external sonar system is to be triggered by the 3200-XS Sub-Bottom Profiling
System, connect the trigger input of this system to the TRIGGER OUT connector.
11.
Connect an AC power cord to an AC POWER out connector and to the LCD monitor.
12.
Connect an AC power cord to the AC POWER input connector and to the AC power
source.
3.8 System Activation and Test
After the connections to the Deck Unit have been completed, the 3200-XS Sub-Bottom
Profiling System can be activated and some predeployment checks performed prior to
deployment of the tow vehicle as a test to verify that the system is operating properly.
When performing the system activation and test, refer to “Deck Unit Controls and
Indicators” on page 3-3 for the location and description of the controls and indicators on the
Deck Unit. In addition, should the system not activate properly or the predeployment
checks fail, refer to “Troubleshooting” on page 4-7 for some assistance on how to correct
the problem.