Edgetech 3200-XS, User Manual

Page: 33 / 74

3-1
SECTION 3: Setup and Test
Setup and test of the EdgeTech 3200-XS Sub-Bottom Profiling System encompasses
unpacking, inspecting and connecting the system components, including an optional
printer; connecting a navigation system and external sonar systems if required; activating
the system; and verifying operation using the EdgeTech DISCOVER 3200SB software.
This section provides instructions on how to perform these tasks as well as some
information on how to deploy and tow the tow vehicle.
3.1 Unpacking and Inspection
The Deck Unit; the SB-424, SB-216S or SB-512i Tow Vehicle; and the 75-Meter Kevlar
Reinforced Tow Cable are shipped in separate, reusable heavy duty transport cases.
Included also are all the necessary cables and documentation. Before unpacking the
system components, inspect the shipping containers for any damage. Report any damage
to the carrier and to EdgeTech. If the shipping containers appear free of damage, carefully
unpack the components and inspect them for damage. Also check the packing list and
verify that all the items on the list are included. Again, if any damage is found, report it to
the carrier and to EdgeTech. If any items are missing, immediately contact EdgeTech. Do
not install or operate any equipment that appears to be damaged.
Although the items shipped may vary, depending on the customer requirements, the
3200-XS Sub-Bottom Profiling System typically includes the following:
•
Deck Unit
•
SB-424, SB-216S or SB-512i Tow Vehicle
•
75-Meter Kevlar Reinforced Tow Cable
•
AC power cords (2)
•
Software CDs
•
Manuals
After unpacking the system components, be sure to safely store the shipping containers,
including any packing materials, for later use. When transporting or storing the system, all
items should be packed in their original shipping containers in the same manner in which
they were originally shipped, and always store the system in a dry environment when not in
use.