Edgetech 3200-XS, User Manual

Page: 34 / 74

3-2
SECTION 3: Setup and Test
3200-XS Sub-Bottom Profiling System User’s Manual Doc. No. 990-0000026-1000, Rev. 2.3
3.2 Power Requirements
The system power requirements are 120–220 VAC, 50/60 Hz. For the 3200-XS Topside
Processor, the input voltage is auto sensing. For the Power Amplifier you must select
120 VAC or 220 VAC operation manually.
3.2.1 Use of an Uninterruptable Power Supply
The AC power source should be continuously free of high amplitude, high frequency
transients, as this type of interference could cause degraded performance or damage to
the equipment. An uninterruptable power supply (UPS) with power surge protection is
recommended for powering the equipment. However, whether or not a UPS is used, the
AC power source should never be the same as that being used to power electric motors,
such as pumps and winches, on the survey vessel.
3.2.2 Selecting the Power Amplifier Input Power Voltage
To select the Power Amplifier input power voltage, first remove the amplifier from the rack.
Then remove the top cover, locate the board at the lower right corner and switch to the
required input power voltage as indicated by the arrow.
3.2.3 Changing to a Non-US Power Plug
An AC power cord is provided for connecting the Deck Unit to a standard U.S. 3-pronged
outlet. For non-U.S. power outlets you can modify this cord by cutting off the 3-pronged
plug and attaching the appropriate plug. Refer to Table 3-1 for connection information.
NOTE:
The Deck Unit is shipped configured for the end user’s country
voltage requirements.
3.3 Navigation Interface
The 3200-XS Sub-Bottom Profiling System accepts all standard National Marine
Electronics Association (NEMA) 0183 message sentence formats from a connected global
positioning system (GPS) or integrated navigation system.
AC POWER CORD WIRE COLOR FUNCTION
Black AC line
White AC neutral
Green Earth ground
Table 3-1:
AC Power Cord Wiring