31
ENGLISH
INSTRUCTION MANUAL
Using the pulse gauge
Place your hands on the sensors (23) on the
gripbar and read your pulse off the Pulse display.
The numbers are only for guidance.
Cleaning and Maintenance
Wipe the treadmill down regularly with a well-
wrung cloth.
Unplug the machine. Open the motor cover and
remove any dust from the motor and sensor.
Check the condition of the treadmill regularly and
tighten any bolts, screws and nuts as necessary.
If the belt runs unevenly
During operation, the belt may run to the right or
left if one of your legs is stronger than the other.
Always try to run in the middle of the belt.
If the belt runs to the right, tighten the right
adjustment screw or loosen the left adjustment
screw.
If the belt runs to the left, tighten the left
adjustment screw or loosen the right adjustment
screw.
You should only turn the screws half a revolution
at a time. Do not tighten the screws too much, as
this may damage the treadmill.
If the belt slips
If the belt is too loose, it may slip on the rollers or
it may stop when a person steps on it. Turn both
adjustment screws clockwise to tighten the belt.
You should only turn the screws half a revolution
at a time. Do not tighten the screws too much, as
this may damage the treadmill.
Overload cut-out
The treadmill is equipped with an overload cut-
out. If the treadmill stops suddenly and the
computer is still on, turn off the power and wait
around 1 minute before turning it back on again.
