Edge-Core EAP8518, User Manual, Page: 186 / 261

C
HAPTER
23
| Spanning Tree Commands
– 186 –
E
XAMPLE
AP(stp-if-wireless 0: VAP[0])# path-cost 512
AP(stp-if-wireless 0: VAP[0])#
port-priority (STP
Interface)
This command sets the spanning tree path cost for the VAP interface.
S
YNTAX
port-priority < priority >
priority - The priority for the VAP interface. (Range: 0-63)
C
OMMAND
M
ODE
Global Configuration (STP interface)
C
OMMAND
U
SAGE
◆
This command defines the priority for the use of an interface in the
Spanning Tree Protocol. If the path cost for all interfaces on a bridge
are the same, the interface with the highest priority (that is, lowest
value) will be configured as an active link in the spanning tree.
◆
Where more than one interface is assigned the highest priority, the
interface with lowest numeric identifier will be enabled.
E
XAMPLE
AP(stp-if-wireless 0: VAP[0])# port-priority 10
AP(stp-if-wireless 0: VAP[0])#
show bridge stp
This command displays displays the global spanning tree settings for the
bridge.
S
YNTAX
show bridge stp
C
OMMAND
M
ODE
Exec
E
XAMPLE
AP#show bridge stp
Bridge STP Information
==================================
Bridge MAC : 00:12:CF:A2:54:30
Status : Disabled
priority : 32768
Hello Time : 2 seconds
Maximum Age : 20 seconds
Forward Delay : 15 seconds