Edge-Core EAP8518, User Manual, Page: 184 / 261

C
HAPTER
23
| Spanning Tree Commands
– 184 –
E
XAMPLE
AP(config)# bridge stp port-conf interface wireless 0
Enter Wireless configuration commands, one per line.
AP(stp-if-wireless 0)#
bridge-link path-
cost
Use this command to configure the spanning tree path cost for the
Ethernet port.
S
YNTAX
bridge-link path-cost < cost>
cost - The path cost for the port. (Range: 1-65535)
D
EFAULT
S
ETTING
4
C
OMMAND
M
ODE
Interface Configuration (Ethernet)
C
OMMAND
U
SAGE
◆ This command is used by the Spanning Tree Protocol to determine the
best path between devices. Therefore, lower values should be assigned
to ports attached to faster media, and higher values assigned to ports
with slower media.
◆ Path cost takes precedence over port priority.
E
XAMPLE
AP(if-wireless a)#bridge-link path-cost 1 50
AP(if-wireless a)#
bridge-link port-
priority
Use this command to configure the priority for the Ethernet port.
S
YNTAX
bridge-link port-priority < priority>
priority - The priority for a port. (Range: 1-255)
D
EFAULT
S
ETTING
32
C
OMMAND
M
ODE
Interface Configuration (Ethernet)