Manual
Errorr 2 – Elevator flaw. ** ELEV-SOBE **
A flaw on the elevator ascent procedure is interrupted indicates electromechanical
problems. Check if there are no obstacles blocking the elevator movement. Check
- OK
Errorr 3 - Elevator flaw ** ELEV-DESCE **
A flaw on the elevator descent procedure is interrupted indicates
electromechanical problems. Proceed as the previous item. Check - OK
Errorr 4- “heating speed equals zero” ** VELOCIDADE **
Indicates that the speed is adjusted at zero at T2. Check - OK
Errorr 5- “heating speed equals zero” ** VELOCIDADE **
Indicates that the speed is adjusted at zero at T1. Check - OK
Errorr 6 –Attempt to change the standard recipe** REC-PADRÃO **
The standard recipes cannot be changed. Save the new recipe in another available
position in the memory. Check - OK
ERROR - 07 - Vacuum flaw – ** FALHA-VÁCUO **
Message:- It was not possible to crate the vacuum. Check - OK
ERROR - 08 - Vacuum flaw – ** FALHA-VÁCUO **
Message:- It was not possible to turn the vacuum off. Check - OK
ERROR - 09 - Version updating flaw ** PROGRAMA **
Message:- Current furnace base incompatible version. Check - OK
ERROR - 10 - A/D conversion flaw ** TEMPERATURA **
Message:- Temperature over the allowed limit. Check - OK
ERROR - 11 - Piston flaw ** COMPRESSOR **
Message:- The compressed air pressure is too low. Check - OK
ERROR - 12 - Programming flaw ** PRENSAGEM **
Message:- The pressing time should be shorter that the burn one. Check - OK
ERROR - 13 - Programming flaw ** PRENSAGEM **
Message:- Vacuum and burn time should be teh same Check - OK
ERROR - 14 - Programming flaw ** ARGÔNIO **
Message:- It is not possible to program argon washing without vacuum. Check -
OK
ERROR - 15 - Programming flaw ** NIGHT **
Message:- This function can only occur in baseline T1 with the elevator on the
base. Check – OK
ERROR - 16 - Serial port flaw RS-232 ** COMUNICAÇÃO **
Message:- It was not possible to connect the furnace. Check - OK
ERROR - 17 - Movable tray device flaw ** START **
Message:- Elevator tray out of the correct base. Check - OK
21
Summary of Contents for press2 alumini
Page 1: ...Manual ...
