Versatrax 150™
Document: UMDW014058.docm
Revision: A03
Created by: KW
Date: 10 Oct 2019
3075415-A03
Source Location: C:\ePDM\ISLEng\products\dw-versatrax150mkii\manuals\UMDW014058.docm
Page 45 of 57
User Ma
nual
Rear Camera Installation
The Versatrax™ system comes ready to accept a rear facing Sapphire™ camera. The plug-in whip is
included with the harness block at the back of the vehicle. The Sapphire camera will come supplied with
a mounting bracket and installation hardware. Note that for inline configurations below 200 mm (8 in)
diameter may not have enough clearance for the rear camera.
WARNING:
High Voltage.
The mating whip is supplied 70 VDC. This whip must
be capped with a dummy plug whenever the Sapphire is removed. Shock or
system damage may otherwise result. Never operate the system with this
connector open.
Note:
The Sapphire camera uses a higher voltage and different pin-out than the Amber camera
which is used on other Eddyfi Technologies equipment. You cannot use the Amber with the
Versatrax system. Attempts to install the Amber camera will damage the connector and burn
out the camera.
Installation
1. Remove the cable clamp holding the camera whip.
2. Install the camera bracket as shown using 2x M4 x 8 mm PHMS.
3.
Install the camera using 2x M3 x 16 mm PHMS.
Note the camera orientation marked “TOP” seen
on the label inside the epoxy.
4.
Plug the mating whip into the camera
–
make sure to align the pins and grease the male
connector.
5. Secure the locking collar after plugging in the camera.
