Versatrax 150™
Document: UMDW014058.docm
Revision: A03
Created by: KW
Date: 10 Oct 2019
3075415-A03
Source Location: C:\ePDM\ISLEng\products\dw-versatrax150mkii\manuals\UMDW014058.docm
Page 24 of 57
User Ma
nual
4. Install the connector while the camera is part way in. Push the whip connector
all
the way onto
the camera. Make sure there is no gap between the rubber faces of the connectors. Screw the
locking collar onto the bulkhead connector; finger tight is good. Periodically apply a small amount
of silicone grease to the connector to keep it lubricated; however, avoid too much grease in the
female socket (vehicle side) because this can make the connector difficult to plug in.
5. Move the camera all the way to the rear tight to the camera mounting plate. Slide the connector
into the square opening and install the camera screws. Use
M6 x 16 mm
SHCS
– note that older
cameras may use ¼-20 x
5
/
8
in SHCS.
M6x16mm SHCS
