Ecreso HELIOS 100W, User Manual

Page: 64 / 127

Head Office : Parc d’activites Kennedy - 20, avenue Neil Armstrong – F-33700 Bordeaux-Merignac (France)
Tel +33 (0)5 57 928 928 – Fax +33 (0)5 57 928 929 –
www.ecreso.com – contact@ecreso.com
Helios 20, 50 or 100 W, User Manual – 01/2011
Page 64
3DB=Threshold Set the threshold to activate the RF alarm (3dB)
If threshold=xxxx Fix the alarm threshold and set the AUTO3DB parameter in OFF.
If threshold=OFF Stop power alarm and sets OFF the AUTO3DB on OFF.
If threshold=AUTO The AUTO3DB parameter is set ON. In this case, the threshold
calculation is done in each output of LOCAL mode, splitting in
two the transmitted HF power.
>3DB=100
100 -> alarm threshold fixed at 100W.
AUTO3DB? Displays the calculation mode of the automatic or manual
power alarm thresholds
>AUTO3DB?
ON
ALARM3DB? Displays information about a 3dB alarm.
>ALARM3DB?
ON
ALARMTEMP? Displays an overheating alarm.
>ALARMTEMP?
OFF
ALARMVSWR? Displays information about a VSWR alarm.
>ALARMVSWR OFF
AUDIO? RDS option and FM transmitter available.
If NONE No options.
If RDS RDS option.
If MON FM transmitter option.
If RDS/MON RDS and FM transmitter options.
>AUDIO?
RDS/MON
CLREVENT? Erases the fault appeared during the last change to LOCAL
mode (see EVENT command).
>CLREVENT?
OK
CODER? Displays information on the coder connected.
If ANALOG Analog coder.
If NONE No coder.
If coder. (mono or stereo).
If DIGITAL Digital coder (mono or stereo).
If XXX Other options.
>CODER?
ANALOG