16
11.
Attach burner door knobs with #8-32 x ¼” screws and
#8-32 hex nuts. Slide bottom of lower access door(s)
in slots on top of manifold brackets. Figure 23.
12.
Position control access jacket panel(s) so tabs slide into
slots on top/front intermediate jacket panel(s). Attach
control access jacket panel to top/front intermediate
jacket. Use (2) #10 x ½” screws. Figure 24.
13.
Lighting Instruction Plates are provided with each
INSTALLATION – ASSEMBLY
Figure 22
Figure 21B
NOTE: The attachment of the control access jacket
panels can wait until the controls have been mounted
to the top/front intermediate jacket panels.
Figure 24
Figure 23
boiler base. Each boiler base also includes data plate
indicating required gas type, fi ring rate, and gas
pressure for that base. These plates are located on
Jacket Top/Front Panels. Boilers also have rating plate
showing total Input and Output Ratings. This rating
plate is shipped in AC Carton and is to be mounted on
side Jacket End Panel by installing contractor.
14.
Attach Local Code Label (not provided by
manufacturer.)
