17
Step 2 Clean Ozone Generating Cores (Singlets) (#15 below)
a. There are two (2) Singlets to remove and clean.
They are shown side by side as #15 in this picture:
b. Remove the electrical connector from each (purple circles, picture on next page)
c. Unscrew the 2 nuts holding each Singlet unit (white circles above).
d. Gently pull out in parallel each Singlet from its leading screws (exposed, in white
circles in picture below, shown after removal of Singlets).
Handle unit carefully.
e. Clean the units under warm tap water, especially the gaps between the tubes*.
You may use a soft brush to remove any accumulated dirt.
Use care not to wet the electrical connector.
f. Dry the Singlet units with a soft towel.
Continued Next Page
*Note: the tubes used in the ActivO are unlike tubes used in competitive ozone machines
which are often fragile and easily broken. The ActivO tubes are specially designed for use in
rugged DR (disaster recovery) environments.