13
Step 5. – Install Cartridge Filter and Attach Sump
Remove the protective plastic wrap from the sediment pre-filter and place it in the cartridge
filter housing sump. At the bottom of the sump, there is a raised portion in the middle
(standpipe) that will help center the filter in the housing. The standpipe will fit inside the hole
that runs through the middle of the filter cartridge. Check to make sure that the black O-ring
is seated properly in the grove at the top of the housing sump, then screw the housing sump
containing the filter cartridge onto the cartridge filter housing cap. Hand tighten only - do not
use the spanner wrench. Do not over-tighten! Excessive force is not required to obtain a
good seal.
.
Step 6. – Connect Outlet Assembly to the ecoTAC™ Bypass Assembly
Thread the outlet assembly on to the outlet side of one of the bypass assemblies as shown.
This bypass assembly will be used on the ecoTAC™ system. Note the position of the fitting
stop. The threaded collar of the outlet adapter should thread right up to the fitting stop.
If there is a gap between the outlet adapter’s collar and the fitting stop, it is not threaded on
far enough. Excessive force is not required to obtain a good seal. Do not over-tighten.
Summary of Contents for EP-600-ULT
Page 8: ...8 Step 1 Pre Installation Inspection...
Page 17: ...17 go to next page...