13
Program and function instruction
1
、
Power on
Connect your appliance to the mains supply, all indicator lights of the display board will light
up for 1s and then remind the user to input the time. Default time show 12:00, hour 12 will
flash, the time can be input at this stage, refer to clock setting requirement for details.
After 10s without any operation and the display will change to adjust minute.
Within 10s without any operation when adjusting minute,the oven will enter standby mode
automatically.
Under standby mode,if no any operation in 5 minutes, the oven will switch off automatically,
and the display screen is not displayed.
When the oven is switch off,you can change to standby mode by means of key or function
knob,and the standby mode displays the real time system clock and clock icon.(Refer to pic
below for the display effect.)
Initial standby mode
When oven is powered on,the oven door lock will start to self-checked. During the self-
examination, the door lock will walk back and forth automatically.
If the correct position
signal is not detected within 20 seconds, the error code will show "E-3",and it will need to
long press
“ ” for 3s to return to standby status.
2
、
Set clock
Under standby status, touching
“
” once into the clock adjustment state.This time hour
value of the clock will flash(1 time/second), by rotating programming switch KB2 to set the
hour time. (0~23~0 is recyclable).
Hour adjustment display effect Minute adjustment display effect
After adjusting the hour time, re-touch
“ ” to switch to minute adjustment. Minute value
will flash at this time, by rotating programming switch KB2 to set minute time
（
0~59~0
recyclable
）
.
After adjusting the minutes, re-touch the
“
” key to confirm, clock setting accomplished,
and at this time, the second icon ":" flashes (1S/1 time).
Adjust hour, hour icon "h" display, adjust minutes, minute icon "min" display. After
confirmation, hour icon and minute icon do not show. If the clock setting is not confirmed
within 10 seconds, the system defaults to complete the clock and automatically returns to
standby. If the clock is not adjusted within 10 seconds after power on, the system defaults to
12:00 and is on standby. If the power is off, the clock will be readjusted.
There will be only system clock displayed under standby status.