Front panel (E-321)
Remote Sensor:
Detects infrared signal from remote control unit.
POWER Indicator:
while the receiver is power on and at standby mode.
Card Slot:
One CA Interface for Conax.
Display:
(LED type) Indicates operating status of receiver. (Optional)
Rear Panel (E-321)
LNB IN:
This port is to connect the coaxial cable from LNB of your Dish.
AV OUT:
This Scart connector is used to connect TV using Scart cable.
HDMI:
Audio and Video output socket for TV set with HDMI Input Jack only.
Ethernet:
(optional) Network port, you can get a new software updates from this port.
USB B:
USB 2.0 Host, connect to USB hard disk, or flash disk.
S/PDIF:
Digital Audio output
With External Audio / Hi-Fi System :
To connect any external Audio Hi-Fi system, the receiver has been provided
with RCA connector at the back of the receiver marked with AV OUT. Connect an RCA cable from the AV OUT jack
on the back of the receiver to the LINE, AUX, SPARE OR EXTRA input jacks on your Hi-Fi System.
TV with Motorized System (DiSEqC 1.2):
Connect one end of your coaxial cable to the LNB IN connector on the
receiver and the other end to the REC or Receiver connector on the DiSEqC 1.2 motor. Connect the coaxial cable
from the LNB to the LNB connector on the DiSEqC 1.2 motor. All our receivers are designed to be DiSEqC 1.0 and
DiSEqC 1.2 compatible. This allows multiple antennas to be connected to the receiver at the same time. If you have
two or more fixed antennas or LNBs, then we recommend you use a DiSEqC 1.0 switch. Connect the coaxial cable
from the first LNB to the LNB 1 or LNB A input connector of the DiSEqC switch. Do the same for any other LNBs that
you have. Connect one end of a coaxial cable to the RF output connector of the DiSEqC switch, connect the other
end to the LNB IN socket on the receiver. To the digital receiver, you can connect either a single satellite antenna
directly or LNB of multi-feed equipment
.
