Page 10
ecom-B
The position of the measured and calculated values (gas analysis)
can be selected freely on the display. To change the position or the
composition, please proceed as follows:
-with
<Enter> / <Display values> / <Enter>
activate the first line on
the display
-choose with curser key the measured or calculated value
-with
<Enter>
activate the next line on the display and so on
-with
<ESC>
or
<Enter>
in the last line you leave this process.
The values for CO
2
, Efficiency, Losses, Lambda and the Dew Point
are calculated values. They just can be calculated when realistic
figures for the basic values like O
2
and the temperature are available.
It must be assured that:
O
2
< 20,5 %
and
T.Gas – T.Air > + 5°C
The dew point can just be calculated correctly if in the menu “Ad-
justments / Air pressure” the current barometric air pressure has
been entered. If the combustion gas temperature falls below the dew
point /between 25 and 65°C) the efficiency will be calculated with
condensation gain. In this case a (C) is displayed behind the effi-
ciency . Correct measurement values are displayed after a delay of 1
to 1,5 minutes necessary for the gas transport to the sensors and to
establish a stable electrochemical reaction in the sensors. For stor-
age and printing wait for the values to become stable. If the gas val-
ue still fluctuates for more than 2 ppm, the reason could be in an
unstable draft condition in the gas channel.
Once the measurement values are stable
and the results can be printed, press
<store>
to transfer the values to the tem-
porary memory. Data will be stored here for
later printout (the values of the temporary
memory could be checked by pressing
<Enter>
/
<store>
/
<Enter>
. While check-
ing the values the gas pump will be
switched off in order to spare the sensors.
(back with
<ESC>
).
O2
4.0
%
CO2
12.5
%
CO
30
ppm
Lambda
1.23
T.Gas
166
°C
T.Air
20
°C
Losses
7.0
%
Eta
93.0
%
Measurement stored
in temporary memory
Summary of Contents for B
Page 1: ...Operating Instructions ...
