ecoclima CM2-H16/4DR2, Service Manual

Page: 25 / 47

23
● Items to be checked after the installation
Table 14
Items to be Checked Possible Errors Check Results
Has each part and component of the
unit been installed securely?
The unit may fall off ,vibrate or generate noise.
Has the gas leakage test been taken?
The cooling (heating) capacity may
be poor.
Is the thermal insulation sufficient? Dews and water drops may be generated.
Does the drainage go well? Dews and water drops may be generated.
Is the actual power voltage in line with the value marked
on the nameplate?
The unit may break down or some
components may be burnt out.
Are the wiring and piping correct?
The unit may break down or some
components may be burnt out.
Has the unit been earthed reliably? There may be a danger of electric shock.
Does the wire meet the regulated requirement?
The unit may break down or the components
may be burnt out.
Is there any obstacle at the air inlet/outlet of the indoor/
outdoor unit?
The cooling (heating) capacity may
be poor.
Have the length of the refrigerant pipe and the refrigerant
charge been recorded? It may be hard to know the exact refrigerant
charge.
● Trial Running
1. Check before the Trial Running
(1) Check if the appearance of the unit and the piping system are damaged during the transportation.
(2) Check if the wiring terminals of the electronic component are secure.
(3) Check if the rotation direction of the fan motor is right.
(4) Check if all valves in the system are fully opened.
2. Trial Running
(1) The trial running should be carried out by the professionally skilled personnel on the premise that all items above
are in normal conditions.
(2) Let the unit energized and switch the wired controller or the remoter controller to “ON”.
(3) The fan motor and compressor of the outdoor unit will run automatically in one minute.
(4) If there is some unusual sound after the compressor is started, turn off the unit for an immediate check.