ecoclima CM2-H16/4DR2, Service Manual

Page: 40 / 47

34
Procedure Note
10. Remove 4-way valve assy
Unsolder the spot weld of 4-way valve assy,
compressor and condenser, and then remove
the 4-way valve assy .
Warning
Discharge the refrigerant completely before
unsoldering,when unsoldering, wrap the gas
valve with awet cloth completely to avoid
damage to thevalve caused by high
temperature.
When unsoldering the spot weld, wrap the
4-way valve with wet cloth completely to avoid
damaging the valve due to high temperature.
11. Gas liquid separator and diaphragm
Open the suction of spot welding, remove the suction
pipe. Use a screwdriver unscrewed the fixed screw of gas-
liquid separator, the upward gas-liquid separator, remove
the gas-liquid separator . Use screw knife clapboard and
chassis have fixed screw drive, remove the partition .