• mounting at eye level for easy reading of the display;
• no mounting on a badly insulated outer wall;
• no direct sunlight;
• no interference from heat sources such as radiators, TV sets, lamps,
refrigerators,etc;
• no mounting next to a window;
• greatest possible distance to metal objects to avoid any
unnecessary
reduction of the operating range
6.2. Mounting the wall holder
Proceed as follows to mount the wall holder:
• Remove the wall holder on the back of the heating control, slide it down for
this;
• Place the wall holder vertically against the wall with the round side pointing
up (see picture);
• Mark the positions of the bores through the two slotted
holes;
• Depending on the type of wall drill two 6 mm holes and
insert suitable dowels.
When drilling the bores and
tightening the screws make sure not to damage any
power lines or gas or water pipes, etc.!
• Fix the wall holder using the enclosed screws. Pay attention
that the two recessed slotted holes for the screws point in
your direction;
• If not already done so, insert the batteries into the heating control before
you slide the heating control on the wall holder;
• Sliding of the heating control on the wall holder is now possible from the top.
6.3.Setting the Date and Time
• If the display is protected by a foil, remove it;
• If batteries have not been inserted yet, proceed as de- scribed in chapter 4
to insert them. After inserting the batteries an automatic display test is per-
formed (all segments and displays of the LC display are displayed for several
seconds). After the display test you may set the year, the month, the day, the
hours and the minutes on the heating control.
10
