ThE gEO sOlENOid
assEMBlY
with the frame separated from the Geo body and the
solenoid Assembly and bbss Assembly unplugged
from the circuit board (see page 62) use a 5/64” hex
key to undo and remove the two screws that hold
the solenoid Assembly onto the Geo body
(sEE
FigUrE13.1).
with the solenoid Assembly completely removed from
the Geo body the bottom of the Geo body should now
resemble
FigUrE 13.2
ensure that the air transfer holes
in the bottom of the body are free from contamination
from any dirt, debris, paint or moisture and clear away
any excess grease if it appears to be blocking any of the
transfer holes.
check the underside of the solenoid Assembly to
ensure that it is also free from damage or debris
(sEE
FigUrE 13.3)
and remove the rubber gasket to clean
the filter section as shown in
FigUrE 13.4
replace the
rubber gasket ensuring that it lies flat in its designated
groove in the minifold body
(sEE FigUrE 13.5)
.
if you are replacing a defective pilot Assembly, unscrew
it from the minifold now and replace it with a new pilot
Assembly unit
(sEE FigUrE 13.6).
warNiNg: dE-gas YOUr MarKEr, dischargiNg
aNY sTOrEd gas iN a saFE dirEcTiON, aNd rEMOVE
ThE BarrEl, lOadEr aNd air sYsTEM TO MaKE ThE
MarKEr EasiEr TO wOrK ON.
WARNING
(cONTiNUEd)
connect the solenoid and break beam sensor system
wiring harnesses to their respective ports on the Geo
circuit board and
(sEE FigUrE 12.10).
Adjust the wires so that they sit neatly in the Grip
frame and ensure that the wires do not obstruct either
the micro-switch or the opto sensor
(sEE FigUrE 12.11).
Attach the Geo rubber Grips to the frame using a 5/64”
hex key to replace the 6 grip screws
(sEE FigUrE 12.12).
screw the inline regulator back into the front
regulator mount and connect any hosing that was
disconnected earlier
(sEE FigUrE 12.13).
you have now installed your Geo Grip frame onto the
Geo.
Fig 13.2
Fig 13.3
Fig 13.4
Fig 13.5
Fig 13.6
Fig 13.1
Fig 12.10
Fig 12.11
Fig 12.13
Fig 12.12
M
AI
N
TE
N
AN
CE
64.
CONTENTS
ORIENTATION
QUICK SET-UP
USING YOUR GEO
ADVANCED SET-UP
MENU TREE
MAINTENANCE
FAULT FINDING
SERVICE CENTERS
PARTS LIST
SPARES & ACCESSORIES
65.
M
AI
N
TE
N
AN
CE
MAINTENANCE
QUicK gUidE
Summary of Contents for GEO
Page 1: ......
