164
Various Settings
How to record a security code
A [SEC] message appears, in two
seconds it will change to [MS].
ATTENTION
• If a Memory Stick has already
been inserted, a [MS EJECT]
message appears. In this case,
eject the Memory Stick and insert
again. (Refer to "Ejecting the
Memory Stick" on page 147 for
details on ejection of the Memory
Stick.)
• If the security is already activated,
recording the security code
function is not available.
A [- - - -] (security code input display)
appears.
(Refer to "Listening to MG Memory
Stick" on page 43 for details on
insertion of the Memory Stick.)
Enter a four-digit security code using
digits 0 to 9, A to F. The number
(shown on the display) changes in
ascending order between 0 and 9, A
and F each time the button is
pressed. Each button number (1 to 4)
corresponds to each digit (first to
fourth) of the security code.
The security code is registered in the
deck and security is set.
The registered security code is
encrypted and then written to
Memory Stick.
ATTENTION
When the security code is registered
using a Memory Stick that contains
several kinds of data, such as music, etc.,
be careful not to clear the recorded data
by formatting the Memory Stick.
Refer to "Ejecting the Memory Stick"
on page 94.
How to cancel the Memory Stick
security
The security function can be cancelled when
the security code that has been recorded with
the deck is entered and verified.
Cancelling the security function can be done by
entering the security code into the deck, or by
using the Memory Stick.
Cancelling the security function by
entering the security code
A [SEC] message appears, then in
two seconds it will change to [- - - -]
(Security code input display).
How to operate the ESN
(Memory Stick) security
1
Check that the unit is in
standby.
2
Press and hold button [1], then
the [FUNC] button, and hold both
for more than one second.
3
Insert the Memory Stick into the
slot and close the front panel.
4
Input a security code by pressing
buttons [1] to [4].
5
Press the [FUNC] button for
more than one second.
6
Eject the Memory Stick.
1
Check that the unit is in standby.
2
Press and hold button [1], then
the [FUNC] button, and hold both
for more than one second.
