166
Various Settings
How to change the Memory Stick
You can change the Memory Stick and
security code that have been recorded by
the deck to a different Memory Stick and
security code.
Refer to "How to cancel the Memory
Stick security" on page 98.
Refer to "How to record a security
code" on page 97.
How to resume normal operation
(ESN security lock out)
If power is disconnected while ESN security
is active (a security code was recorded),
operation is disabled until power is restored
and the unit unlocked. Follow this procedure
to resume normal operation.
ESN security lock can be cancelled by
directly entering the security code into the
deck, or by using the Memory Stick that was
being used when the security code was
recorded.
Cancelling ESN security lock out
using security code entry
Enter a four-digit security code using
digits 0 to 9, A to F. The number
(shown on the display) changes in
ascending order between 0 and 9, A
and F each time the button is
pressed. Each button number (1 to 4)
corresponds to each digit (first to
fourth) of the security code.
If the security code matches the code
recorded by the deck, [OK] will
appear on the display and the
security function will be cancelled.
ATTENTION
• If the security code does not
match the information recorded by
the deck, [ERR_ ] (ERR and the
error number) will appear on the
display for two seconds, and then
[- - - -] (security code entry
display) will appear. If this
happens, check the security code
and repeat the procedure from
step 2.
• If [ERR5] (the 5th time an error
has occurred) appears, [HELP] will
appear. When [HELP] appears,
carry out the operations for an
ESN security lock out by following
the procedure in "What happens if
a Memory Stick or security code is
incorrect?" on page 167.
1
Cancel the security code that has
been recorded with the deck.
2
Re-record the new Memory Stick
and security code that you would
like to use.
1
When the power is turned on after
disconnecting the battery power,
a [SEC] message will appear for
two seconds. Thereafter,
message changes to [- - - -]
(Security code input display).
2
A security code is entered by
pressing the buttons [1] to [4].
3
Press the [FUNC] button for more
than one second.