15
14
8.2 Transport
•
In order to avoid injury or damage to the unit it must be handled
properly. In addition to following the instructions below, general health
and safety good practice and specific accident prevention guidelines
should be observed.
•
For correct handling and storage comply with the following symbols:
Protect against moisture
Careful: glass
Up
Centre of gravity
•
Do not compress the side walls of the unit or any attached parts by
pulling obliquely on ropes or chains.
•
Only remove handling safeguards once all installation work has been
completed.
•
When handling in a loading area make sure the unit cannot topple over
or slip.
•
Damage caused during transportation must always be reported to the
manufacturer.
8.3 Storage
•
If possible the unit should be stored in a closed room until final
installation.
•
If the unit is stored in the open it must be covered over with tarpaulins
and open underneath, to allow condensation to drain off.
•
If the unit has been packed for transportation by sea the packaging must
not be damaged or opened during transit and storage.
•
For correct storage comply with all storage and handling symbols:
Protect against moisture
Careful: glass
Up
