6
Mount the reflector on the mast and point the reflector.
Slide the reflector down onto
the mast. Make sure the azimuth plate rests on top of the mast. Turn the reflector so that it points
in the general direction of the satellites, using the azimuth angle you wrote on page 4.
Note
: The DISH 500+ mast clamp may have a gripping feature that helps prevent movement of
the mast clamp when fully installed. This gripping feature may have a slightly rough feel when
installing the mast clamp onto the mast or when adjusting the azimuth angle.
For DISH 1000+ installation, attach LNBF.
For DISH 1000+ installations, attach a separate
DP Dual (or DP Single) to the 1000+ LNBF bracket using the included washers and screws. Slide
the bracket onto the DP 500+ LNBF assembly. Place the nut into the retaining feature on the
back of the assembly. Insert the screw from the front of the assembly and tighten according to the
torque value (see Table 1 on page 9) to attach the bracket. See Figure 4.
Note
: Handle the LNBF assembly using the DBS/FSS Dual Band LNBF. Do not handle it by the
110°W or 129°W brackets or LNBFs.
Figure 4. Optional bracket for attaching DP Dual (or DP Single) for 129°W
8.
9.
