8
For DISH Pro Plus LNBF assembly
: Connect the tempoary cable to
Port 1
(119°W) of the
LNBF (see Figure 6).
Figure 6: DISH Pro Plus 500+ and 1000+ LNBF Assembly with Port 1 (119°W)
Peak the reflector for signal on the 119°W
. Peak the reflector for signal on the 119°W
satellite sign and transponder 13 using the azimuth and elevation settings you wrote on page 4.
Do not adjust the skew.
Note
: If you cannot find the 119°W signal, try adjusting the elevation up or down one or two
degrees. Ensure you are peaking the reflector using transponder 13.
Tighten three mast bolts and reconfirm signal strength.
With the peaking meter still
connected, tighten the three mast bolts labeled with a T to the torque values listed in Table 1 (see
Figure 7). Reconfirm signal strength after tightening the bolts.
Figure 7. Mast bolts
4.
LNB In
LNB In
Mast
Bolts
3.
