CHAIN BRAKE SYSTEM
20
DCS-1600
3-2 Replacing brake lever
[Disassembling]
1. Remove brake switch from motor cover.
2. Remove bolt (E) and collar (F).
3. Remove bolt (B), washer (C) and collar (D).
4. Remove brake lever (A).
5. Check torsion spring (G). If deformed or broken,
replace with new one.
[Assembling]
6. Install torsion spring (G) to brake lever (A) as
shown.
7. Set hole of brake lever (A) on boss (T) of motor
cover and install brake lever (A) to motor cover.
8. Apply molybdenum grease on inner surface of
collar (D).
9. Install collar (D) in boss of brake lever (A).
10. Place washer (C) on brake lever (A) and se-
cure the washer (C) with bolt (B).
11. Place callor (F) in boss of brake lever (A) and
secure the collar (C) with bolt (E).
E
F
B
C
D
A
A
A
G
A
T
A
Apply molybdenum
grease on inner
surface
B
C
A
E
F
D
