![background image](http://html1.mh-extra.com/html/ecg/ewf-1062-da/ewf-1062-da_instruction-manual_3963306054.webp)
GB
54
Power connection
•
This appliance is designed for power supply 220~240V/50Hz.
•
The power cable of your washing machine is equipped with special plug with grounding
pin. This plug should only be connected to a grounded outlet in an outlet circuit with a 10
A fuse. If you do not have such an outlet with 10 A fuse, ask a qualified electrician for the
installation.
•
We are not liable for damages caused by use without proper grounding.
Note:
Use of the appliance at low voltage will result in shortening the service life and lower
efficiency.
Connecting the water supply
•
Your washing machine is equipped with a cold water inlet.
•
In order to avoid water leakage at the joining points, a nut is supplied with the hose, which
has to be fitted on the water inlet hose on the side of the water tap.
•
Screw on the new water inlet hose onto the tap with thread ¾ inches.
•
Connect the white end of the supply hose, equipped with an elbow, to the white inlet with
filter on the back of the machine. Tighten the plastic connecting nuts manually. If you are
unsure about the connection, entrust it to a qualified installer.
•
The water inlet pressure should be in the range 0.03 ~ 1.0 MPa. If the water pressure is
higher, install the pressure reducer into the line.
•
After connecting, open the tap fully and check that there are no leaks at joints.
•
Ensure that the new supply hose is not folded, cracked or pinched and that it is of the
original length.
Note:
When connecting the washing machine use exclusively new hoses, supplied with the
washing machine. Never use old, used or damaged water hoses.
3/4”
10 mm
Connecting the drain hose
•
End of the drain hose can be attached to a special facility for
sewage drain or a special outlet on the sink siphon.
•
Never try to extend the length of the drain hose using clamps.
•
Make sure that the drain hose is not folded, twisted, pinched and
that it has the original length.
•
Fix the drain hose to a height of 85 ~ 125 cm above the floor.
•
Do not put the drain hose into the sink, bucket or basin with no
outlet.
M
in. 85 cm
M
ax. 125 cm
Summary of Contents for EWF 1062 DA+++
Page 2: ......