ECG EWF 1062 DA+++, Instruction Manual

Page: 62 / 72

GB
62
1. Make sure that the drum of the washing machine is empty before cleaning.
2. Open the detergent drawer and pour bleach into the main wash compartment. Do not add a detergent or
soap to avoid excessive foaming. Close the detergent drawer
3. Make sure that the washing machine is connected to the power supply and the water inlet is open.
4. Turn on by pressing the button
1
.
5. Press for at least 3 seconds together the buttons
Spin speed
and
Temperature selection
. This activates
the self-cleaning program.
6. Press the button Start/Pause , when you close the door, the self-cleaning program starts. A beep sounds
when program is finished. Once the program ends, dry the interior of the washing machine.
Child lock
The washing machine is equipped with child lock function, which prevents change to the currently run
program by an unintended pressing of a button or by turning the control knob.
• When the washing machine is running press for at least 3 seconds the button Delayed start . The child lock
is activated and the washing machine settings can not be changed now, all except the power switch are
inactive. Deactivate the child lock by long pressing again the button
Delayed start
.
• If you want to change the washing program when the child lock is active, deactivate the child lock first and
restart the washing machine so that a new program can be selected. If you want to change temperature
or spin speed, deactivate the child lock, press the button Start/Pause and then change the temperature
setting or spin speed.
Automatic door lock
When a program is selected, the washing machine door are automatically locked. Release the lock two minutes
after the program ends.
Restoring the program after a power failure
When power is restored the program continues from the point where it was interrupted.
Delayed start
Press the button Delayed start to select the time when the program should start. The display shows time,
which you can change by repeated pressing of the button Delayed start .
Adding laundry function
If you decide to add laundry after starting the program, stop the machine by pressing the “Start/Pause” button.
After 5 seconds you will hear an unlocking sound and the door lock symbol will disappear. Then you can open
the door and add the required laundry items. Do not attempt to open the door by force, since this may cause
damage. If there is too much foam and water in the drum, water may leak out when it is opened.
The door can not be opened when the drum is in motion, the water temperature is higher than 45°C, and there
is plenty of water inside.
In the event of a power failure longer than 2 minutes, the door can be opened provided the above conditions
are met (water level below drum seal, water temperature below 45°C, zero speed).
Restart the washing machine by pressing the button “Start/Pause”. A click sounds, the door lock relocks. If a “dE”
error message appears, check that the door is properly closed.
CLEANING AND MAINTENANCE
• Unplug the machine before maintenance or cleaning.
• Close the water tap before starting maintenance or cleaning.
Warning:
If you use cleaners containing solvents, you could damage
parts of the washing machine. Do not use agents containing
solvents for cleaning.